Process

Raw Material

The Raw material used for manufacturing of Transformer Lamination & Stampings are Cold Rolled Grain Oriented Electrical Steel, Cold Rolled Non-Grain Oriented Electrical Steel, and hot Rolled Steel. The Raw Material are purchased either from International Market or from Domestic Market in the Form of Coil or Sheets.

Slitting

The Raw Material is Slit to the required width on slitting machine or on press/machine.

Shearing

After Slitting Process material on Sheared Machine as per drawing and design of the customers.

'V' Notching

If required as per the design, `V' Notching is done on the press/machine.

Hole Punching

Required as per the design, hole punching is done on the Hole Punching press/machine.

PROCESS

For Inquiry